The Heart Sure BP100 Upper-Arm Blood Pressure Monitor is easy to use with it's simple one-touch operation. It features last reading memory and displays blood pressure values and pulse rate.
• Simple one-touch operation
• Last Reading Memory
• Soft Cuff (Med)
• Display of Blood Pressure Values & Pulse Rate
Boxed Contents: Main unit, arm cuff, instruction manual, 4 x AA batteries
Always read & follow the instructions for use & health warnings. For people with high blood pressure. Consult your doctor to evaluate the readings. Check your device periodically for accuracy
Please see instruction manual for full list of warnings.
• Consult your physician before using the device for any of the following conditions: common arrhythmias such as atrial or ventricular premature beats or atrial fibrillation, arterial sclerosis, poor perfusion, diabetes, pregnancy, pre-eclampsia, masectomy, renal disease or severe blood flow problems or blood disorders as cuff inflation can cause bruising
• Always consult your doctor. Self-diagnosis of measurement results and self-treatment are dangerous
• Do not adjust medication based on measurement results from this blood pressure monitor. Take medication as prescribed by your physician. Only a physician is qualified to diagnose and treat High / Low Blood Pressure
• The monitor is not intended to be a diagnostic device
• Do not use the unit for any purpose other than measuring blood pressure
• Do not use the device on the injured arm or the arm under medical treatment
• Do not wrap the arm cuff on the arm while being on an intravenous drip or blood transfusion
• Consult your physician before using the device on the arm with an arterio-venous (A-V) shunt
• Do not apply or inflate the arm cuff around any body parts other than your upper arm
• Do not take measurements more than necessary. It may cause bruising due to blood flow interference
• Remove the arm cuff if it does not start deflating during the measurement
• The air tube or the AC adapter cable may cause accidental strangulation in infants
• Keep out of reach of children. Contains small parts that may cause a choking hazard if swallowed
• If there are any abnormalities during the measurement, remove the arm cuff
• Do not use this device on infants, children or persons who cannot express themselves
• Do not inflate the arm cuff more than necessary
• Stop using this monitor and consult your doctor if you experience skin irritation or discomfort
• Use only the approved arm cuff for this unit. Use of other arm cuffs may result in incorrect measurement results
• Do not use a mobile phone or other devices that emit electromagnetic fields, near the unit. This may result in incorrect operation of the unit
• Do not use the device with other medical electrical (ME) equipment simultaneously
• Do not use this monitor in areas containing high frequency (HF) surgical equipment, magnetic resonance imaging (MRI) equipment, computerized tomography (CT) scanners or in oxygen rich environments
• Follow the battery/ AC adaptor instructions carefully
Cuff- LATEX FREE
Please see instruction manual for detailed instructions.
• Avoid bathing, drinking alcohol/caffeine, smoking, exercising and eating for 30 minutes before taking a measurement
• Rest for at least 5 minutes before taking the measurement
• Sit upright on a chair with your legs uncrossed and feet flat on the floor, with your back and arm being supported
• Remove tight-fitting clothing from your arm. Do not roll up a tight sleeve. Do not place the arm cuff over thick clothes
• Wrap the arm cuff firmly in place around the left upper arm. Please see instruction manual if needing to use the right arm.
• The bottom edge of the arm cuff should be 1 to 2 cm above your elbow
• The air tube should be on the inside of your arm and aligned with your middle finger
• Rest your arm on a table so that the arm cuff is at the same level as your heart
• Ensure solid connection of the airplug and cuff to main unit
• Ensure you remain still and do not talk during the measurement
• Press the START/STOP button
• The cuff will inflate and a result will display on the screen (approx. 30-60 secs)
• The reading will be automatically saved in the memory
STORAGE INSTRUCTIONS
-20 to +60 °C / 10 to 95 % RH / 700 to 1060 hPa
